Camera bracket mount

This is great for using Ethernet cable to move power and data on a single CAT-5 cable. Although I believe it's made mostly for security cameras due to connectors on the sending and receiving cables, I suppose it can be used for anything as long as the voltage doesn't exceed higher than 60v.A great use for me personally was to put a small 5 port Ethernet switch in a location that I had no access to an outlet. The voltage for the switch is 5v, but connector was different. Had to do some DIY to change the connector but when finished, I was able to power the switch and distribute the data to other devices.I should also note that this setup may be best used in 10Mb and not suitable for 100Mb or Gigabit networks, since the cabling uses 4 of available 8 wires in the CAT-5 cable for distributing power.

Works great swapped out a bunch of old analog cams that used cat 5e with bnc baluns and power connectors just terminated with a rj45 and used this the new cams were ip but not poe these worked perfectly just connect one end to the cameras rj45 and 12v power then on the other side plug the rj45into the same network switch as your nvr or a switch that's on the same vlan as your nvr and connect a power connector and run a line to a 12v power distribution box I used a 9channel cause I have 8 cameras that way u don't have to use 8 separate power adapters plugged into a surge protector that's a fire hazard waiting to happen

Great value pack and excellent quality and performance.Need to power an Access Point, Camera, etc but no AC outlets are nearby ? this is the product you need. We had a unique situation where we had three (3) access points to install in locations where no AC power outlets were installed. This would not be a problem if the Access Points could be powered by POE but these units could only be powered by a 12VDC power adapter. These adapters allowed us to centrally power the APs while sending data and power over the same cable. All is well that ends well.

Works as expected. Use em for routers and sometimes non-poe cameras

Still working well used with my IP cameras with good throughput and line speed.

These worked great. I only used 3 of them but, for the price you can't go wrong. I have two left for the next time.

product is amazing when combined with shorter PoE cables, but it simply does not have the ability to carry such a current through 100 ft.update: you can definitely still use it, just make sure you use a good power supply. I needed 12 volts at 2 amps for 8 cams; about 24 watts a piece. I bought a 360 watt 12 volt 30 amp power supply and simply connected 2.1x5.5 lines to it. these adaptors work fine, even with the extra juice ( needed due to 100ft being too great)

None of the 5 splitters worked. 0V on output. Plugged in multiple devices none worked. Tried multiple Ethernet cables. Measured voltage with known working Fluke 87 meter. Checked devices with 12V power brick, all were working. Returning for refund.

Fonction bien